Article ID Journal Published Year Pages File Type
4429798 Science of The Total Environment 2012 10 Pages PDF
Abstract

The majority of small, remote communities within the Northern Territory (NT) in Central Australia are reliant on groundwater as their primary supply of domestic, potable water. Saturation indices for a variety of relevant minerals were calculated using available thermodynamic speciation codes on collected groundwater data across the NT. These saturation indices were used to assess the theoretical formation of problematic mineral-scale, which manifests itself by forming stubborn coatings on domestic appliances and fixtures. The results of this research show that 63% of the measured sites within the NT have the potential to form calcium carbonate (CaCO3) scale, increasing to 91% in arid, central regions. The data also suggests that all groundwaters are over-saturated with respect to amorphous calcium-bridged ferric-silica polymers, based on the crystalline mineral index (Ca3Fe2Si3O12), although the quantitative impact of this scale is limited by low iron concentrations. An assessment of possible low-cost/low-technology management options was made, including; lowering the temperature of hot-water systems, diluting groundwater with rainwater and modifying the pH of the source water. Source water pH modification (generally a reduction to pH 7.0) was shown to clearly alleviate potential carbonate-based scale formation, over and above the other two options, albeit at a greater technical and capital expense. Although low-cost/low-technology treatment options are unlikely to remove severe scale-related issues, their place in small, remote communities with minor scale problems should be investigated further, owing to the social, technical and capital barriers involved with installing advanced treatment plants (e.g. reverse osmosis) in such locations.

► Scaling potential of small communities reliant on hard groundwaters were analysed. ► Oversaturation of carbonate- and silica-based minerals was widespread. ► Low-cost/-tech treatment options were assessed for treating mineral precipitation. ► Lowering reticulation water temperature and dilution with rainfall proved ineffective. ► Modifying pH (to 7.0) had the greatest impact, albeit at a greater technical cost.

Related Topics
Life Sciences Environmental Science Environmental Chemistry
Authors
, , , ,