Article ID | Journal | Published Year | Pages | File Type |
---|---|---|---|---|
4484039 | Water Research | 2010 | 9 Pages |
Membrane biofilm reactors (MBfR) utilize membrane fibers for bubble-less transfer of gas by diffusion and provide a surface for biofilm development. Nitrification and subsequent autotrophic denitrification were carried out in MBfR with pure oxygen and hydrogen supply, respectively, in order to remove nitrogen without the use of heterotrophic bacteria. Excessive biomass accumulation is typically the major cause of system failure of MBfR. No biomass accumulation was detected in the nitrification reactor as low-level discharge of solids from the system balanced out biomass generation. The average specific nitrification rate during 250 days of operation was 1.88 g N/m2 d. The subsequent denitrification reactor, however, experienced decline of performance due to excessive biofilm growth, which prompted the implementation of periodic nitrogen sparging for biofilm control. The average specific denitrification rate increased from 1.50 g N/m2 d to 1.92 g N/m2 d with nitrogen sparging, over 190 days thus demonstrating the feasibility of stable long-term operation. Effluent suspended solids increased immediately following sparging: from an average of 2.5 mg/L to 12.7 mg/L. This periodic solids loss was found unavoidable, considering the theoretical biomass generation rates at the loadings used. A solids mass balance between the accumulating and scoured biomass was established based on the analysis of the effluent volatile solids data. Biofilm thickness was maintained at an average of 270 μm by the gas sparging biofilm control. It was concluded that biomass accumulation and scouring can be balanced in autotrophic denitrification and that long-term stable operation can be maintained.