Article ID Journal Published Year Pages File Type
4684444 Geomorphology 2014 18 Pages PDF
Abstract

•Morphological analyses were performed in several cave systems in quartz–sandstones.•SEM studies revealed that arenisation is an effective process.•Rock primary porosity, composition and jointing degree guide weathering intensity.•Pillars, floor bumps and pendants are the expression of the arenisation process.•Iron hydroxides and silt layers represent guiding inception horizons.

A detailed petrographic, structural and morphometric investigation of different types of caves carved in the quartz–sandstones of the “tepui” table mountains in Venezuela has allowed identification of the main speleogenetic factors guiding cave pattern development and the formation of particular features commonly found in these caves, such as funnel-shaped pillars, pendants and floor bumps. Samples of fresh and weathered quartz–sandstone of the Mataui Formation (Roraima Supergroup) were characterised through WDS dispersive X-ray chemical analyses, picnometer measurements, EDAX analyses, SEM and thin-section microscopy. In all the caves two compositionally different strata were identified: almost pure quartz–sandstones, with content of silica over 95% and high primary porosity (around 4%), and phyllosilicate-rich quartz–sandstone, with contents of aluminium over 10% and low primary porosity (lower than 0.5%). Phyllosilicates are mainly pyrophyllite and kaolinite. SEM images on weathered samples showed clear evidence of dissolution on quartz grains to different degrees of development, depending on the alteration state of the samples. Grain boundary dissolution increases the rock porosity and gradually releases the quartz grains, suggesting that arenisation is a widespread and effective weathering process in these caves. The primary porosity and the degree of fracturing of the quartz–sandstone beds are the main factors controlling the intensity and distribution of the arenisation process. Weathering along iron hydroxide or silt layers, which represent inception horizons, or a strata-bounded fracture network, predisposes the formation of horizontal caves in specific stratigraphic positions. The loose sands produced by arenisation are removed by piping processes, gradually creating anastomosing open-fracture systems and forming braided mazes, geometric networks or main conduit patterns, depending on the local lithological and structural guidance on the weathering process. This study demonstrates that all the typical morphologies documented in these quartz–sandstone caves can be explained as a result of arenisation, which is guided by layers with particular petrographic characteristics (primary porosity, content of phyllosilicates and iron hydroxides), and different degrees of fracturing (strata-bounded fractures or continuous dilational joints).

Related Topics
Physical Sciences and Engineering Earth and Planetary Sciences Earth-Surface Processes
Authors
,