Thermal conditions of the central Sinai Microplate inferred from new surface heat-flow values and continuous borehole temperature logging in central and southern Israel

This paper reports ten new surface heat-flow density (qs) values for central and southern Israel (central Sinai Microplate), whose crystalline crust and lithosphere formed as part of the Neoproterozoic Arabian-Nubian Shield. Heat flow was calculated in Mesozoic sediments using the classical approach of heat-flow determination by implementing in the analysis high-precision continuous temperature logs obtained in air- and/or water-filled boreholes. Thermal conductivity (TC) measured for a large suite of rock samples of lithotypes making up the sequence was assigned to temperature gradients in intervals for which the lithology was known. The heat-flow values obtained for different depth intervals in a borehole as well as the average values for the individual borehole locations cover a narrow range, attesting heat-conduction conditions. A steady-state thermal model along an E–W crustal cross section through the area shows that the observed systematic spatial distribution of the qs values, which range between 50 and 62 mW m−2, can primarily be explained by variations in the thickness of the upper crust and in the ratio between sedimentary and crystalline rocks therein. Given the time lapse of thermal heat transfer through the lithosphere, the qs data monitor the crustal thermal conditions prior to rift- and plume-related lithospheric thermal perturbations that have started in the larger area ca. 30 Ma ago. Observed and modeled qs display the best fit for a pre-Oligocene lithosphere–asthenosphere boundary (LAB) at ∼150 km, which would be at the upper end of LAB depths determined from stable areas of the Arabian Shield (150–120 km) not affected by the young, deep-seated thermal processes that have caused a further uprise of the LAB. Our data imply or predict that the surface heat flow of the Sinai Microplate generally tends to increase along N–S and W–E traverses, from ∼45–50 mW m−2 to ∼55–60 mW m−2. Surface heat flows on the order of 55–60 mW m−2 may be common in the northern Arabian Shield, where it exhibits typical lithosphere structure and composition and is unaffected by young heating processes, compared to values of ≤45 mW m−2 recently determined in the southern Arabian Plate for the Arabian Platform.