Article ID Journal Published Year Pages File Type
4733274 Journal of Structural Geology 2012 16 Pages PDF
Abstract

Friction data used in modelling studies of subduction zone seismogenesis are often poorly representative of in situ conditions. We investigated the influence of in situ effective stresses and temperatures on the frictional properties of (simulated) fault gouges, prepared either from Nankai ODP material or illite shale, at sliding velocities approaching those relevant for earthquake nucleation and SSEs. Biaxial (double direct shear) experiments were performed at room temperature, normal stresses of 5–30 MPa, and sliding velocities of 0.16–18 μm/s. All materials exhibited velocity strengthening under these conditions, along with an increase in the friction coefficient and slip hardening rate with increasing normal stress. Illite gouge showed increased velocity strengthening towards higher normal stresses. The effect of temperature was investigated by means of ring shear experiments on illite gouge at 200–300 °C, an effective normal stress of 170 MPa, a pore-fluid pressure of 100 MPa and sliding velocities of 1–100 μm/s. These experiments showed a transition from velocity strengthening to velocity weakening at ∼250 °C. Our results provide a possible explanation for the updip seismogenic limit within subduction zone megathrusts and imply an enhanced tendency for earthquake nucleation and SSEs at low effective normal stresses.

► New data on frictional behaviour of (simulated) subduction zone megathrust gouges. ► Smectite and illite gouges used to address different depth ranges. ► Velocity strengthening in all cases, but weakening in illite gouge at T > 250 °C. ► Illite data offer explanation for updip seismogenic limit in subduction zones. ► Enhancement of unstable slip at low effective normal stress in all materials.

Related Topics
Physical Sciences and Engineering Earth and Planetary Sciences Geology
Authors
, , , , ,