Article ID | Journal | Published Year | Pages | File Type |
---|---|---|---|---|
4920595 | Engineering Structures | 2017 | 12 Pages |
Abstract
Fibre Reinforced Polymers (FRP) have been proven to be adequate substitutes for steel reinforcement under aggressive environments for flexural Reinforced Concrete (RC) elements. Their mechanical properties, basically their lower modulus of elasticity, derive in larger crack widths and deflections, in particular when Glass-FRP (GFRP) bars are used. Moreover, their different bond behaviour, mainly due to their mechanical properties and different surface configurations, make necessary to assess the available equations to determine crack width need to be assessed. This paper presents a study on the cracking behaviour of GFRP RC elements based on the results of an experimental programme involving 15 beams. The paper studies the influence of the reinforcing material, Ï/Ïeff ratio, concrete cover, stirrup spacing and bond between the concrete and the reinforcement. For this purpose, two different types of GFRP and steel bars were used. The cracking behaviour (crack width and spacing) in the pure bending zone was analysed up to the service load. Crack width was consistently acquired by using a Digital Image Correlation (DIC) technique. The 2D full-field displacements of the pure flexural zone were registered using 4 digital cameras and commercial software that enables the evolution of the specimen cracks to be analysed. Finally, bond coefficients have been adjusted to different formulations in terms of crack spacing and crack width.
Related Topics
Physical Sciences and Engineering
Earth and Planetary Sciences
Geotechnical Engineering and Engineering Geology
Authors
C. Barris, L. Torres, I. Vilanova, C. Mià s, M. Llorens,