Effects of polymerization conditions on the in vitro hydrolytic degradation of plaques of poly(dl-lactic acid-block-ethylene glycol) diblock copolymers

In the case of poly(lactic acid) stereocopolymers, it has been shown that the hydrolytic degradation of derived devices depends very much on whether zinc lactate or tin octoate was used to polymerize lactides. In contrast, no effect was found in the case of nanoparticles derived from poly(dl-lactic acid)-block-poly(ethylene glycol) copolymers obtained by anionic polymerization of dl-lactide initiated by the sodium salt of monomethoxypoly(ethylene glycol) or by coordination-insertion polymerization of dl-lactide initiated by monomethoxypoly(ethylene glycol) in the presence of tin octoate as catalyst. To understand the difference of behaviour, in vitro hydrolytic degradation of thick plates made of the same copolymers but under different conditions was investigated. Changes were monitored by 1H Nuclear Magnetic Resonance, Size Exclusion Chromatography, Electrospray Mass Spectrometry and Capillary Zone Electrophoresis. It is shown that chain cleavage occurred from the very beginning of degradation and that plates disintegrated after 13 weeks. In all cases, degradation proceeded faster inside than at the surface, in contrast to what was observed for nanoparticles. Tin-type copolymer plates degraded more slowly than sodium macroalcoholate-type ones and were sensitive to purification conditions, in contrast to the latter.