Article ID | Journal | Published Year | Pages | File Type |
---|---|---|---|---|
5353316 | Applied Surface Science | 2014 | 7 Pages |
Abstract
In this paper, we aim to evaluate feasibility of replacing tin oxide (SnO2) films by in-line sputtered (titanium, aluminum)-doped zinc oxide (TAZO) as a front electrode of hydrogenated amorphous silicon (a-Si:H) thin film solar cells. The HCl wet-etching process and the device performances are investigated and optimized. The results show that the textured TAZO can have a lower sheet resistance of 7 Ω/square and a higher haze of 22% compared to commercial Asahi-U SnO2 films. The a-Si:H solar cells with a TAZO front contact is found to have a low fill factor due to a poor TAZO/p-a-Si:H interface. However, the interface problem can be significantly improved by inserting a microcrystalline p-layer silicon thin-film. In addition, the reproducibility of the wet-etching process is investigated. The fluctuation in the haze of the etched TAZO films can be obviously reduced when a multi-step wet-etching process is used. Moreover, the light soaking test is performed on the TAZO films. Only slight degradation in film properties indicates high stability with respect to time. These results encourage potential adoption of cost-effective in-line sputtered TAZO films as an alternative for the front contact of a-Si:H thin film solar cells.
Related Topics
Physical Sciences and Engineering
Chemistry
Physical and Theoretical Chemistry
Authors
Shui-Yang Lien, Chia-Hsun Hsu, Chia-Hung Chang, Hsin-Yu Wu, In-Cha Hsieh, Da-Yung Wang,