| Article ID | Journal | Published Year | Pages | File Type |
|---|---|---|---|---|
| 5354853 | Applied Surface Science | 2015 | 30 Pages |
Abstract
In this study, Laser Engineered Net Shaping (LENSTM) was employed towards Additive Manufacturing/3D Printing of Ti-Si-N coatings with three different Ti-Si ratios on commercially pure titanium (cp-Ti) substrate. Microstructural analysis, phase analysis using X-ray diffraction, wear resistance and hardness measurements were done on LENS⢠processed 3D printed coatings. Coatings showed graded microstructures and in situ formed phases. Results showed that microstructural variations and phase changes influence coating's hardness and wear resistance directly. High hardness values were obtained from all samples' top surface where the hardness of coatings can be ranked as 90% Ti-10% Si-N coating (2093.67 ± 144 HV0.2) > 100% Ti-N coating (1846 ± 68.5 HV0.2) > 75% Ti-25% Si-N coating (1375.3 ± 61.4 HV0.2). However, wear resistance was more dependent on inherent Si content, and samples with higher Si content showed better wear resistance.
Related Topics
Physical Sciences and Engineering
Chemistry
Physical and Theoretical Chemistry
Authors
Yanning Zhang, Himanshu Sahasrabudhe, Amit Bandyopadhyay,