| Article ID | Journal | Published Year | Pages | File Type |
|---|---|---|---|---|
| 5361254 | Applied Surface Science | 2012 | 5 Pages |
Zr-Si-N films were deposited on silicon and steel substrates by cathodic vacuum arc with different N2/SiH4 flow rates. The N2/SiH4 flow rates were adjusted at the range from 0 to 12Â sccm. The films were characterized by X-ray diffraction (XRD), X-ray photoelectron spectroscopy (XPS), scanning electron microscope (SEM), hardness and wear tests. The structure and the mechanical properties of Zr-Si-N films were compared to those of ZrN films. The results of XRD and XPS showed that Zr-Si-N films consisted of ZrN crystallites and SiNx amorphous phase. With increasing N2/SiH4 flow rates, the orientation of Zr-Si-N films became to a mixture of (1Â 1Â 1) and (2Â 0Â 0). The column width became smaller, and then appeared to vanish with the increase in N2/SiH4 flow rates. The hardness and Young's modulus of Zr-Si-N films increased with the N2/SiH4 flow rates, reached a maximum value of 36Â GPa and 320Â GPa at 9Â sccm, and then decreased 32Â GPa and 305Â GPa at 12Â sccm, respectively. A low and stable of friction coefficient was obtained for the Zr-Si-N films. Friction coefficient was about 0.1.
⺠In this paper, we investigate the microstructure and mechanical properties of Zr-Si-N films deposited with different N2/SiH4 flow rates while keeping other parameter constant during the deposition process. ⺠The phase structure, surface and cross-section morphologies. ⺠The mechanical properties are systematically studied.
