Article ID | Journal | Published Year | Pages | File Type |
---|---|---|---|---|
5366802 | Applied Surface Science | 2011 | 7 Pages |
AlTiN films with different nitrogen partial pressures were deposited using arc ion plating (AIP) technique. In this study, we systematically investigated the effect of the nitrogen partial pressure on composition, deposition efficiency, microstructure, macroparticles (MPs), hardness and adhesion strength of the AlTiN films. The results showed that with increasing the nitrogen partial pressure, the deposition rate exhibited a maximum at 1.2Â Pa. Results of X-ray photoelectron spectroscopy (XPS) analysis revealed that AlTiN films were comprised of Ti-N and Al-N bonds. XRD results showed that the films exhibited a (1Â 1Â 1) preferred growth, and AlTi3N and TiAlx phases were observed in the film deposited at 1.7Â Pa. Analysis of MPs statistics showed MPs decreased with the increase in the nitrogen partial pressure. In addition, the film deposited at 1.2Â Pa possessed the maximum hardness of 38Â GPa and the better adhesion strength.
⺠We prepared the Al-Ti-N films with high Al contents by multi-arc ion plating. ⺠We examined the structure of the Al-Ti-N films by XRD and XPS. ⺠We systematically evaluated the macroparticles, hardness and adhesion strength of the Al-Ti-N films.