Nanometric thinning of bonded silicon wafers using sacrificial anodic oxidation and investigated by X-ray reflectivity

X-ray reflectivity and atomic force microscopy are used to investigate silicon oxide ultra-thin films. Quantitative results are shown using a reflectivity simulation model based on kinematical X-ray theory. Changes in film thickness are discussed in relation to current density, voltage, charge and anodization time. The density and resistivity of silicon oxide are calculated and compared to that of thermal oxide. The electrical field existing in the layer during anodization is estimated. Surface roughness is also measured locally and averaged over the entire surface, producing a low value that meets microelectronic requirements. Thickness is carefully controlled. We show that ultra-thin silicon oxide films are of very high quality. Similar investigations are made on a twisted bonded silicon substrate obtained by the molecular bonding of two silicon wafers. It is shown that the silicon oxide is also of very good quality and can be used as a sacrificial silicon oxide in thinning down the upper silicon film. Controlled, accurate thinning is achieved down to a thickness of 10 nm, the level which is required for etching the dislocation network present at the bonding interface.