Transport properties of glassy and molten lavas as a function of temperature and composition

We provide measurements of thermal diffusivity (D), heat capacity (CP), and viscosity (η) for 12 remelted natural lavas and 4 synthetic glasses and melts, ranging in composition from leucogranite to low-silica basalt, and calculate their thermal conductivity. Both viscosity and the glass transition temperature decrease with decreasing melt polymerization. For basaltic glasses, D is low, ~ 0.5 mm2 s− 1 at room temperature, decreases slightly with increasing temperature, and then drops upon melting to ~ 0.25 to 0.35 mm2 s− 1. Other samples behave similarly. Despite scatter, clear correlations exist between D of glass or melt with Si content, density, NBO/T, and, most strongly, with fragility (m). Glass thermal diffusivity is represented by D = FT− G + HT, where F, G and H are fitting parameters. For melts, ∂ D/∂ T was resolved only for dacite-andesite and MORB: a positive slope is consistent with other iron-bearing samples. Glass and liquid CP depend on density and other physical properties, but not exactly in the same manner as D. We calculate thermal conductivity (k) from these data and demonstrate that k for glasses is described by a Maier-Kelly formula. Large scatter exists for k at 298 K, but silicic to intermediate melts have k between 1.8 and 1.3 Wm− 1 K− 1, whereas basaltic melts are constrained to ~ 1.4 ± 0.1 Wm− 1 k− 1. Low values for thermal diffusivity and viscosity for basaltic melts suggests that basalts transfer heat much more efficiently by advection than by conduction alone, and that partially molten zones in the mantle quickly become more thermally insulating than non-molten zones, potentially contributing to melt localization during decompression melting.