Carbonate effects and pH-dependence of uranium sorption onto bacteriogenic iron oxides: Kinetic and equilibrium studies

The removal of U(VI) from groundwaters by adsorption onto bacteriogenic iron oxides (BIOS) has been investigated under batch mode. The adsorbent dosage, the uranium concentration, the concentration of carbonate and the use of a real groundwater spiked with uranium comprised the examined parameters. In addition, the effect of pH was examined in two different water matrixes, i.e., in distilled water and in real groundwater. Equilibrium studies were carried out to determine the maximum adsorption capacity of BIOS and the data correlated well with the Langmuir and Freundlich models. The presence of carbonate affected adversely the adsorption of U(VI) onto BIOS. The maximum adsorption capacity of BIOS was 9.25 mg g−1 at 0.1 mM carbonate concentration and decreased to 6.93 mg g−1 at 0.5 mM carbonate concentration, whereas at carbonate concentration of 2 mM practically no adsorption occurred. The data were further analyzed using the pseudo-second order kinetic equation, which fitted best the experimental results. The initial adsorption rate (h) was found to increase with decreasing the concentration of carbonate in all cases. When experiments were accomplished in the absence of carbonate, the pH values did not have an effect on the adsorption of U(VI). However, the extent of U(VI) adsorption was strongly pH-dependent when the experiments were carried out in the real groundwater. The maximum adsorption capacity increased sharply as the pH decreased and optimum removal was obtained in the pH range 3.2-4.0, thus bacteriogenic iron oxides can found application in the removal of U(VI) by adsorption from low pH or low carbonate waters.