Article ID Journal Published Year Pages File Type
585743 Journal of Hazardous Materials 2006 9 Pages PDF
Abstract

This paper deals with the application of Soy Meal Hull (SMH), an agricultural by-product, for the removal of direct and acid dyes from aqueous solutions. Four textile dyes, C.I.Direct red 80 (DR80), C.I.Direct red 81 (DR81), C.I.Acid blue 92 (AB92) and C.I.Acid red 14 (AR14) were used as model compounds. Physical characteristics of SMH such as surface area, Fourier transform infra-red (FTIR) and scanning electron microscopy (SEM) were obtained. The surface area of SMH was found to be 0.7623 m2/g and the presence of functional groups such as hydroxyl, amine and carbonyl groups were detected. The effect of initial dye concentration, pH, contact time and SMH doses were elucidated at 20 ± 1 °C. Results show that the pH value of 2 is favorable for the adsorption of all four dyes. The data evaluated for compliance with the Langmuir, Freundlich and BET isotherm models. It was found that data for DR80 and DR81 fitted well with Langmuir isotherm, for AB92, BET isotherm is preferred, while for AR14, the Freundlich isotherm is the most applicable. The adsorption capacities of SMH for DR80, DR81, AB92 and AR14 were, 178.57, 120.48, 114.94 and 109.89 mg/g of adsorbent, respectively. Also, adsorption kinetics of dyes was studied and the rates of sorption were found to conform to pseudo-second order kinetics with good correlation (R2 ≥ 0.9977). Maximum desorption of ≥99.8% was achieved for DR80, DR81 and AB92 and 86% for AR14 in aqueous solution at pH 10. Based on the data of present investigation, one could conclude that the SMH being a natural, eco-friendly and low-cost adsorbent with relatively large adsorption capacity might be a suitable local alternative for elimination of dyes from colored aqueous solutions.

Related Topics
Physical Sciences and Engineering Chemical Engineering Chemical Health and Safety
Authors
, , , ,