Friction and wear behaviour of stainless steel rubbing against copper-impregnated metallized carbon

A series of experimental tests were carried out using stainless steel rubbing against copper-impregnated metallized carbon under electrical current on a pin-on-disc test rig. The test parameters include the sliding speed of 60-100 km/h, normal force of 40-80 N and electrical current of 0-50 A. During testing, the friction coefficient and wear volume were recorded. The topography of worn surfaces was also observed with SEM. The cross sectional profiles of worn surfaces of stainless steel were measured with Ambios profiler. The result displays that electrical current, normal load and sliding speed have a distinct effect on the friction and wear behaviour of stainless steel rubbing against copper-impregnated metallized carbon. Without electric current, the friction coefficient is largest but the wear volume of copper-impregnated metallized carbon is lowest. With increasing electric current, the friction coefficient decreases while the wear volume of copper-impregnated metallized carbon increases. Through the whole test, it is found that the wear loss of stainless steel was light. The wear of copper-impregnated metallized carbon becomes severe when electrical current or sliding speed is high. When the electrical current or sliding speed is high, arc ablation is a dominant wear mechanism of copper-impregnated metallized carbon.