Article ID | Journal | Published Year | Pages | File Type |
---|---|---|---|---|
617677 | Wear | 2013 | 11 Pages |
Abstract
The disulphides of tungsten and molybdenum are known for their low friction properties when used as solid lubricants. Due to their low hardness, their load bearing capacity when used as thin films is poor. When carbon is added to a WS2 coating, both of these shortcomings are improved, and a structure consisting of nanocrystals of WS2, and possibly tungsten carbide, in a matrix of amorphous carbon is formed. In this study, an attempt is made for further increasing the hardness of such coatings, by addition of Ti, a strong carbide former. A number of W-S-C(-Ti) coatings were deposited using magnetron co-sputtering, and characterised with regard to chemical composition, structure and tribological properties. It was seen that addition of Ti significantly increased the hardness of the coatings, while maintaining their excellent low friction properties in dry atmosphere. However, the coatings with Ti showed extremely high initial friction, a feature not seen for the coatings without Ti. The mechanisms behind this running-in behaviour were investigated by studying surfaces at early stages of wear. It was observed that tribofilms formed during sliding for the coatings containing Ti consisted mainly of TiO2, with platelets of WS2 appearing in the contact only after prolonged sliding. For the pure W-S-C coatings, WS2 was observed in the sliding interface almost instantly at the onset of sliding.
Keywords
Related Topics
Physical Sciences and Engineering
Chemical Engineering
Colloid and Surface Chemistry
Authors
H. Nyberg, J. Sundberg, E. Särhammar, F. Gustavsson, T. Kubart, T. Nyberg, U. Jansson, S. Jacobson,