Article ID Journal Published Year Pages File Type
641988 Separation and Purification Technology 2012 8 Pages PDF
Abstract

A novel surface modified Polysulfone (PSf) hollow fiber membrane was fabricated via dry–wet phased inversion process. surface modifying macromolecule (SMM) was used as additive in the spinning dope. The surface modified membrane showed large pore size, higher effective surface porosity, contact angle and porosity but lower critical water entry pressure (CEPw) compared to Polysulfone hollow fiber membrane without SMM. The performance of surface modified membrane in contactor application for CO2 absorption via distilled water as absorbent was studied. The results show that surface modified membrane has higher performance compared to plain Polysulfone membranes. With the membrane prepared from SMM in the spinning dope a maximum CO2 flux of 5.8 × 10−4 mol/m2 s was achieved at 300 ml/min of absorbent flow rate, which was almost 76% more than the other membrane. In a long-term stability study, the initial flux reduction was found to be about 18% within the 50 h of operation for surface modified membrane.

► SMM was used to improve the surface hydrophobicity of PSf HFM. ► Average pore size and contact angle increased by adding SMM in the spinning dope. ► The fabricated PSf HFMs were used in contactor application for CO2 absorption. ► The CO2 flux of the hollow fiber increased by surface modification. ► The CO2 flux decline by partial pore wetting was reduced by surface modification.

Related Topics
Physical Sciences and Engineering Chemical Engineering Filtration and Separation
Authors
, , , ,