Article ID | Journal | Published Year | Pages | File Type |
---|---|---|---|---|
6473622 | Fuel | 2018 | 12 Pages |
The first coalification jump (FCJ) has a significant impact on low-rank coal reservoir heterogeneity, and is of great importance for coalbed methane (CBM) development. Here, a series of experiments were performed for 10 coal samples collected from eastern Junggar Basin, to compare the material composition, pore structure and adsorption capacity of lignite and candle coal. Contrast with the candle coal, the lignite has a higher inertinite content, larger pore volume, better connectivity, and greater specific surface area (SSA). During the process of FCJ, the polycondensation of coal molecules and the compaction of coal matrix occur, leading to a rapid decline of moisture, porosity and permeability, and the cell wall in the candle coal is badly crushed with clay minerals filled from optical microscopy. In general, the larger total pore volume (1.7-300â¯nm, measured by N2 adsorption) contributes to the larger SSA. The SSA of candle coal mainly comes from the contribution of micropore (<10â¯nm), especially the 2-3â¯nm pores, while the micropore and transition pore (10-100â¯nm) contribute to most of SSA of lignite. However, though the SSA of the candle coal is largely lower than that of the lignite, the CH4 adsorption capacity tends to decrease from the lignite to the candle coal due to material composition difference. Low-field NMR was used to determine the pore and fracture system by analyzing the transverse relaxation time, which showed that only two obvious peaks could be identified in lignite and three peaks at about 0.25â¯ms, 30â¯ms and 200â¯ms are present in the candle coal. The fractal results indicate that the pore surface and complexity inside the coal increase gradually from lignite to candle coal. These observations could deepen awareness and understanding of low-rank coal reservoir heterogeneity and the influence of FCJ on reservoir property.