Article ID | Journal | Published Year | Pages | File Type |
---|---|---|---|---|
6606765 | Electrochimica Acta | 2016 | 9 Pages |
Abstract
The microstructure and phase composition of Ni-P and Ni-P-Re layers with medium phosphorus content of 8.8 and 8.2Â wt. % of P, respectively, and 6.8Â wt.% of Re electroless plated on copper substrate were studied. Both of the deposits showed amorphous X-ray profile, however, as it was expected, the presence of small (about 10Â nm in size) nanocrystallites was observed in both kinds of plating under transmission electron microscope (TEM). The crystallization temperatures, measured in the range of 298-773Â K, significantly increased with rhenium content as well as with increasing heating rate and differed by about 40Â K. The activation energy calculated based on the Kissinger's model in the case of Ni-8.2P-6.8Re plating was 217.7Â kJÂ molâ1 and for Ni-8.8Â P was 206.3Â kJÂ molâ1. X-ray diffraction (XRD) measurements of the Ni-P deposits carried out after the heat treatment indicated the presence of the Ni and Ni3P phases, which was confirmed by electron diffraction and high resolution observations in TEM. XRD data concerning Ni-P-Re plating revealed the following phases: Ni, Ni3P, Ni0.21Re0.79, Ni5P2 and NiP, while TEM investigation confirmed the presence of Ni3P, NiP, Ni5P2 so far. Due to the very local information gathered from the TEM, this result needs further studies.
Related Topics
Physical Sciences and Engineering
Chemical Engineering
Chemical Engineering (General)
Authors
J. Wojewoda-Budka, A. Wierzbicka-Miernik, L. Litynska-Dobrzynska, M.J. Szczerba, G. Mordarski, M. MosiaÅek, Z. Huber, P. Zieba,