| Article ID | Journal | Published Year | Pages | File Type |
|---|---|---|---|---|
| 686776 | Chemical Engineering and Processing: Process Intensification | 2016 | 8 Pages |
•Sprays generated by two Venturi-vortex atomizers are experimentally characterized.•Four liquids are tested to analyze the device performance for different viscosities.•The capability to atomize viscous liquid (up to 1 Pa s) is shown.
Atomization of high viscosity liquids for industrial processes requires the design of more efficient atomizers. In this work, the operation of an air-assisted atomizer, based on a Venturi-vortex system, was examined atomizing liquids with increasing viscosity. In this atomizer prototype, air was injected tangentially in a central convergent chamber and discharged axially suctioning liquid from a coaxial compartment through an annular slit. This atomizer is characterized by the generation of a high velocity swirling airstream and the use of large internal liquid passages. The resulting sprays were experimentally analyzed by means of a phase-Doppler Anemometer. The droplet diameter and two velocity components were measured at different axial stations and radial locations along the spray. Operating with low liquid flow rates, a good atomization quality was achieved generating sprays with a significant fraction of small droplets. Drops with diameters up to 50 μm were considered, which constitute 99% of the total number of measured droplets. Sauter mean diameters below 30 μm were obtained even when pure glycerine was atomized. Air/liquid mass flow rate ratios above 7.5 were handled. The effects of varying the air injection pressure and the conical chamber geometry were also investigated. A drop of the atomizer efficiency was noted when a shorter convergent chamber was used.
