Optimization of surface roughness and tool wear in hard turning of austempered ductile iron (grade 3) using Taguchi method

In this work, the cutting parameters are optimized in hard turning of ADI using carbide inserts based on Taguchi method. The cutting insert CVD coated with AL2O3/MT TICN. Experiments have been carried out in dry condition using L18 orthogonal array. The cutting parameters selected for machining are cutting speed, feed rate and depth of cut with each three levels, nose radius in two levels maintaining other cutting parameters constant. The ANOVA and signal to noise ratio are used to optimize the cutting parameters. The cutting speed is the most dominant factor affecting the surface roughness and tool wear. In optimum cutting condition, the confirmation tests are carried out. The optimum cutting condition results are predicted using signal to noise ratio and regression analysis. The predicted and experimental values for surface roughness and tool wear adhere closer to 9.27% and 1.05% of deviations respectively.