Investigation of electrostatic charge distribution within the reactor wall fouling and bulk regions of a gas–solid fluidized bed

The distribution of charge within the wall fouling region and bulk of a fluidized bed reactor was investigated. Experiments were conducted in a 0.1 m in diameter carbon steel fluidization column under atmospheric conditions. Polyethylene particles were fluidized with extra dry air at 1.5 the minimum fluidization velocity (bubbling flow regime) for 1 h. Using an online Faraday cup measurement technique, the net charge-to-mass ratio (q/m), as well as the size distribution of all particles adhered to the column wall and those in the bulk of the bed was determined. The wall particles were found to be predominantly negatively charged while those which did not adhere to the wall were predominantly positively charged. The charge distribution within each region was then investigated by a custom made charged particle separator that separated the particles according to their charge magnitude and polarity. It was determined that although the net charge of the wall layer particles was negative, a significant amount of positively charged particles existed within each sample and therefore the entire wall particle layer. This suggests that the wall layer was formed through layering between positively and negatively charged particles. Particles in the bulk of the bed also consisted of bipolarly charged particles.

► Charge distribution within a polyethylene gas–solid fluidized bed was investigated. ► An instrument was built to determine the fluidizing particles' charge distribution. ► Particles adhered to the column were predominantly negatively charged. ► Those within the bulk of the bed were predominantly positively charged. ► Bipolar charging was detected in both regions.