Article ID | Journal | Published Year | Pages | File Type |
---|---|---|---|---|
735009 | Optics and Lasers in Engineering | 2016 | 10 Pages |
•A novel raster beam method is proposed to fabricate sub-100 nm cross-gratings.•Cross-gratings with a frequency of up to 14,832 lines/mm were successfully prepared.•The number of control parameters for grating fabrication could be reduced to two.•The quality of the gratings was validated by micrographs, moiré fringe patterns and Fourier transform (FT) and phase analysis.•The local strain near a crack was studied to validate the application potential.
The resolution of the electron beam moiré method depends on the line frequency of the grating. Recently, more and more effort has been devoted to increase the frequency, and a novel method for producing high-resolution electron beam gratings is presented in this work. Cross-gratings with a frequency up to 14,832 lines/mm (67 nm pitch) were successfully fabricated using a common scanning electron microscope without a dedicated pattern generation system. The quality of the grating was high enough to produce high-quality moiré fringe patterns. In this method, the ultra-fine cross-grating can be fabricated only through one-directional scanning on the resist, which can improve the grating quality and significantly reduces the fabrication time. The number of control parameters for grating fabrication could be reduced to two compared to the six parameters required by conventional methods, which facilitates the use of the electron beam moiré method. The frequency of the fabricated grating is linearly proportional to the exposure magnification. Thus, the frequency of the grating can be accurately predetermined, and the null field can be easily obtained in the electron beam moiré method. The quality of the fabricated gratings was illustrated by the obtained micrographs and moiré fringe patterns. The full-field local strain near an induced crack was studied to verify the application potential of this method.