Article ID | Journal | Published Year | Pages | File Type |
---|---|---|---|---|
763658 | Engineering Failure Analysis | 2010 | 8 Pages |
This paper presents the experimental results of fatigue life enhancement and the residual stresses around the cold expanded holes in Al 2024, a widely used aerospace alloy. Two techniques for cold expansion of holes, namely split-sleeve with taper pin technique and split-sleeve with ball technique were considered for comparison, as the former involves surface contact and the latter has line contact during expansion. The techniques were compared based on the fatigue life enhancement in the expanded holes, the induced and the residual stresses due to expansion. The holes were expanded by 2%, 3%, 4%, 5%, and 6% using INSTRON machine in both the techniques. While both the techniques resulted in improvement in fatigue life of the expanded holes, the taper pin technique yielded 200% higher fatigue life improvement than that obtained by ball technique. The induced residual stresses were measured by mounting strain gages of 0.2 mm gage length. These are drawn as a function of induced strain. In both the techniques residual stresses increased with increase in percentage of expansion until 5% and then decreased for 6% expansion. The increase in fatigue life at 5% expansion was 1.88 times and 5.3 times higher than that of the non-expanded holes for ball and tapered method, respectively. The corresponding improvement in taper method was greater than the non-expanded holes. While, it was observed that the residual stresses decreased with respect to the distance from the hole in both the techniques, the ball technique resulted in lower residual stresses than that of taper pin technique.