| Article ID | Journal | Published Year | Pages | File Type |
|---|---|---|---|---|
| 764315 | Energy Conversion and Management | 2012 | 8 Pages |
Electrostatically assisted sprays of butanol were established and compared with the ones of fuels of automotive interest, namely ethanol and heptane. First, electrospray phenomenology was investigated through high-speed visualization for a variety of conditions. Then, spray structure was studied through droplet size and velocity measurements, using Phase Doppler Anemometry, for a wide range of flow rates and applied voltages. Particular emphasis was placed on the determination of the dependence of droplet size and velocity on mass flow rate and applied electric field. Visualization and measurements of droplet size and speed revealed an unstable and polydisperse electrospray behavior for most conditions. Several factors were identified as responsible for this unstable behavior and were investigated experimentally for the butanol case. These included: oscillations of e-spray menisci, droplet disruption due to Coulombic fission and secondary droplet break-up because of high Weber numbers.
► Butanol e-spray phenomenology and structure was studied and compared to ethanol and heptane. ► An unsteady behavior that resulted in lack of monodispersity was observed for all cases. ► Sprays emanated from oscillating menisci, which is incompatible with steady cone-jet operation. ► Droplet Weber numbers were measured to be substantial, pointing to secondary droplet break-up. ► Coulombic fission was investigated, but the droplets were charged well below the Rayleigh limit.
