Fractography survey on high cycle fatigue failure: Crack origin characterisation and correlations between mechanical tests and microstructure in Fe–C–Cr–Mo–X alloys

Raw materials were cast from different specific processes in order to produce cleaner steels with a reduced amount of inclusions. Studied materials that are HSS hardened alloys belonging to the Fe–Cr–C–X system were shared out in four groups depending on the tempering temperature and the presence of secondary and primary carbides. Both inclusions and carbides were roughly assessed by means of Image Analysis.Forging was done on all studied materials with different reduction ratios in order to highlight the texture influence on mechanical properties.High cycle fatigue tests were made using the boundary method to allow a quick evaluation of results.Fractographic analyses carried out on broken samples led to the definition of four failure modes depending on the nature and the location of the point from which the crack was initiated in one hand, and the roughness of striations in the propagating area over and around the initiation point. Internal and surface crack initiation points were found, the latter being more harmful than the first ones. Though oxides appeared to be more detrimental than other inclusions, primary carbides were also found to be both crack initiation candidates and crack propagation enhancers.Various parameters likely to influence high cycle fatigue failures were finally defined, the most significant one dealing with the nature and location of embedded precipitates and the forging reduction ratio.