Article ID Journal Published Year Pages File Type
779986 International Journal of Mechanical Sciences 2016 32 Pages PDF
Abstract
Modelling of the cutting forces in micromilling is challenging due to the size effect and existence of a minimum chip thickness. This paper presents the development of a cutting force model for micromilling of brass. The prediction of cutting forces derives from a simplified orthogonal process. A finite element (FE) model is employed to simulate two-dimensional cutting forces in orthogonal microcutting, with the ploughing and tool edge effect taken into consideration. The flow stress of workpiece material is modelled by using the Johnson-Cook constitutive material law. The FE model is used to evaluate the critical chip thickness and to extract the cutting force coefficients. The cutting force coefficients are modelled as a function of instantaneous uncut chip thickness, which is independent of cutting speed but influenced by tool edge radius. To rectify the issue of sharp increase of the force coefficients under very small uncut chip thickness, a critical uncut chip thickness value is introduced and the coefficients are adjusted by using a tangent slope for uncut chip thickness smaller than the critical value. A generalized analytical force model based on numerical findings is developed to predict the micromilling force by considering the tool trajectory and tool runout. The simulation results of micromilling forces are compared against experimental measurement, where an agreement of force trends is shown along with the increasing feedrate and depth of cut.
Related Topics
Physical Sciences and Engineering Engineering Mechanical Engineering
Authors
, ,