| Article ID | Journal | Published Year | Pages | File Type |
|---|---|---|---|---|
| 781346 | International Journal of Machine Tools and Manufacture | 2006 | 7 Pages |
This study analyzes the temperature profile along the cutting edges of a drill and describes how the temperature on the chisel edge can exceed the temperature on the primary cutting edges. A finite element model predicts the temperature distribution in the drill, where the heat flux loads applied to the finite element model are determined from analytical equations. The model for the heat flux loads considers both the heat generated on the shear plane and the heat generated on the rake face of the tool to determine the amount of heat flowing into the tool on each segment of the cutting edges. Contrary to the conventional belief that the maximum temperature occurs near the outer corner of the drill, the model predicts that the maximum temperature occurs on the chisel edge, which is consistent with experimental measurements of the temperature profile.
