Temperature of internally-cooled diamond-coated tools for dry-cutting titanium

•The successful application of an internally cooled tool in dry cutting titanium.•Utilisation of a diamond coating as a heat dissipation and heat transfer layer.•Reduced cutting temperatures and improved tool life.

The role of cutting fluids is well known for the importance of removing heat from the cutting edge, lubricating the sliding chip contact and transporting the metal chips away from the cutting zone. Dry machining leads to increased cutting temperatures and higher wear rates resulting in shorter tool life; this is particularly evident in the cutting of high strength materials. Diamond coated cutting inserts are not usually considered for machining titanium due to rapid oxidation of the coating at the temperatures typical of titanium machining. This paper examines the formation of hot-spots on the rake face during dry and near-dry turning of titanium using conventional cemented carbide inserts. Machining performance is assessed by measurement of tool wear and tool life. Trials with an internally cooled tool with a specially designed, diamond coated insert have shown that the heat from the cutting operation can be rapidly diffused over the entire surface of the insert and thus successfully drawn away from the tool via closed loop recirculation of coolant through the tool holder. This enables wear to be inhibited by management of rake face temperature to keep it below the critical temperatures at which these prominent wear mechanisms operate. Measurements of change in coolant temperature before and after circulation are used to quantify the heat removed from the cutting process. The low friction coefficient and high thermal conductivity of diamond, assisted by the indirect cooling, results in longer tool life whilst maintaining high standards of surface finish.