Grain size, strain rate, and temperature dependence of flow stress in ultra-fine grained and nanocrystalline Cu and Al: Synthesis, experiment, and constitutive modeling

For the first time, high quality bulk nanocrystalline (nc) fcc metals, with least amounts of imperfections, exhibiting high strength and ductility at room and different temperatures, under quasi-static and dynamic types of loading, were prepared and a comprehensive study on their post-yield mechanical properties was performed. This investigation included study of the effect of temperature on stress–strain responses of mechanically milled bulk nc Cu and Al. The samples after preparation through mechanical milling and consolidation processes were subjected to uniaxial compressive loading at quasi-static and dynamic strain rates of 10−2 s−1 and 1840–3105 s−1, respectively, at temperatures ranging from 223 to 523 K. In both materials strong dependency of flow stress to temperature was observed; this dependency was rather more pronounced when the materials were tested at the quasi-static strain rate. Further, a new grain size and temperature dependent viscoplastic phenomenological constitutive equation, Khan–Liang–Farrokh (KLF) model was developed based on the Khan–Huang–Liang (KHL) constitutive equation. The model was featured to correlate different characteristic behaviors of polycrystalline materials in the plastic regime, as the result of grain refinement. In addition, the viscoplastic responses of bulk Cu and Al of different grain sizes (from sub-micron to nanometer range), and those from bulk nc Cu and Al at different strain rates (quasi-static to dynamic), recently published (Khan et al., 2008b and Khan et al., 2008a), were simulated using the newly developed equation. The results confirmed reasonable capability of the developed model to correlate a wide spectrum of the viscoplastic responses of these fcc metals.