| Article ID | Journal | Published Year | Pages | File Type |
|---|---|---|---|---|
| 794739 | Journal of Materials Processing Technology | 2013 | 13 Pages |
•Design a cylindrical surface milling test of low cutting depth and varying lead angle.•Focus on lead angle effect on critical out-of-cut occasion to identify cutter runout.•Identify the dual-cubic polynomial for cutting force specifics in sequence explicitly.•Better milling stability than that of varying cutting depth method for 12Cr steel.
The accuracy of cutting force coefficients plays an important role in predicting reliable cutting force, stability lobes as well as surface location error in ball-end milling. In order to avoid chatter risk of the traditional calibration test with an entire-ball-immersed cutting depth, a cylindrical surface milling method is proposed to calibrate the cutting force coefficients with the characteristics of low cutting depth and varying lead angle. A dual-cubic-polynomial function is also presented to describe the non-uniform cutting force coefficients of the ball part cutting edge and the nonlinear chip size effect on cutting force. The variation of the maximum chip thickness versus the lead angle is established with the consideration of cutter runout. According to the dependence of chip thickness on lead angle, a runout identification method is introduced by seeking the critical lead angle at which one of the cutter flutes is just thoroughly out of cut. Then, a lumped equivalent method is adopted for the low cutting depth condition so that the dual-cubic-polynomial model can be calibrated for the chip size effect and the cutting force coefficients respectively. The accuracy of the proposed calibration method has been validated experimentally with a series of milling tests. The stability examinations indicate that the proposed method has an evident chatter-free advantage, compared with that of varying cutting depth method.
Graphical abstractFigure optionsDownload full-size imageDownload as PowerPoint slide
