Rough terrain profiling using digital image correlation

•Profiling of terrain using digital image correlation using two cameras.•System is inexpensive.•Does not require INS system to piece together individual measurements.•System is tested with discreet and random excitations to the measurement system.

Road profiling is an important aspect of vehicle dynamics simulations especially over rough terrains. The accurate measurement of rough terrains allows for more accurate multi body simulations. Three dimensional road profiles are usually performed by utilising a line scan sensor which measures several points lateral to the road. The sensors range from simple road following wheels to LiDAR sensors. The obtained line scans are longitudinally stitched together using the orientation and position of the sensor to obtain a full three dimensional road profile. The sensor’s position and orientation therefore needs to be accurately determined in order to combine the line scans to create an accurate representation of the terrain. The sensor’s position and orientation is normally measured using an expensive inertial measurement unit or Inertial Navigation System (INS) with high sensitivity, low noise and low drift. This paper proposes a road profiling technique which utilises stereography, based on two inexpensive digital cameras, to obtain three-dimensional measurements of the road. The system negates the use of an expensive INS system to determine orientation and position. The data sets also require subsampling which can be computationally expensive. A simple subsampling routine is presented which takes advantage of the structure of the data sets to significantly speed up the process.