Article ID | Journal | Published Year | Pages | File Type |
---|---|---|---|---|
8032553 | Thin Solid Films | 2018 | 6 Pages |
Abstract
In this study, aluminum oxide (Al2O3) thin films are deposited via spatial atomic layer deposition on p-type silicon wafer. Then, a post-deposition annealing is performed in oxygen to activate the field-effect and chemical passivation. The annealing temperature is varied from 300â¯Â°C to 750â¯Â°C, and its effect on the structural properties and carrier lifetime of Al2O3/Si is investigated. The results show that at the annealing temperature of 600â¯Â°C, the highest minority carrier lifetime obtained is 446.5â¯Î¼s and maximum surface recombination rate is 22.4â¯cm/s. Annealing temperatures higher than 600â¯Â°C lead to deteriorate surface passivation due to insufficient hydrogen passivation and structural change from AlO4 to AlO6 that cause low oxide fixed charge. Photovoltaic performance is simulated and compared with experimental results. The simulation shows that the p-type passivated emitter and rear contact (PERC) solar cell with the Al2O3 single layer annealed at 600â¯Â°C can have open-circuit voltage (Voc) of 678â¯mV and conversion efficiency (η) of 21.96%, while the PERC solar cell with SiNx:H/Al2O3 doubled layer can achieve Voc of 679.7â¯mV and η of 22.03%, which is very close to the upper limit in the case of ideal rear passivation. The simulation is in a good agreement with the fabricated PERC solar cell showing Vocâ¯=â¯679.2â¯mV and ηâ¯=â¯21.6%.
Related Topics
Physical Sciences and Engineering
Materials Science
Nanotechnology
Authors
Chia-Hsun Hsu, Chun-Wei Huang, Jian-Ming Lai, Yun-Chia Chou, Yun-Shao Cho, Sam Zhang, Shui-Yang Lien, Xiao-Ying Zhang, Wen-Zhang Zhu,