Article ID Journal Published Year Pages File Type
8040172 Nuclear Instruments and Methods in Physics Research Section B: Beam Interactions with Materials and Atoms 2015 5 Pages PDF
Abstract
We present initial results of in situ14C system blank and calibration sample measurements obtained using the in situ14C extraction scheme developed at the University of Cologne. The 14C extraction scheme specifically exploits the phase transformation of quartz to cristobalite in order to quantitatively extract the carbon as CO2 and follows a scheme that is different to that of existing extraction systems. Features are offline furnace extraction, single pass catalytic oxidation using mixed copper (I,II) oxide as catalyst, the use of UHV-compatible components and of vacuum annealed copper tubing. The design allows a relatively rapid sample throughput - two samples per day as opposed to the current 2 days per sample that can be done on other lines - and can accommodate samples ranging between 0.5 and 4 g of clean quartz. Following extraction and cleaning, the CO2 gas is measured using the gas ion source of the MICADAS AMS facility at ETH Zurich. The extraction system yields low systems blanks (10 +16/−10 × 103 atoms 14C, ±1 σ) and the initial results indicate that further improvements are achievable. Measurements of the CRONUS-A standard sample show a good reproducibility and results are consistent with published values. We also present the first in situ14C results for the CRONUS-R standard material.
Related Topics
Physical Sciences and Engineering Materials Science Surfaces, Coatings and Films
Authors
, , ,