| Article ID | Journal | Published Year | Pages | File Type |
|---|---|---|---|---|
| 8044128 | Vacuum | 2018 | 21 Pages |
Abstract
The effect of intercritical annealing on the microstructure and mechanical properties of a low carbon steel with the chemical composition (wt%) of 0.12C-1.11Mn-0.16Si is studied. The cold rolled martensite and ferrite-pearlite microstructure are considered as the starting microstructures for producing dual phase (DP) steels. It is revealed that intercritical annealing of cold-rolled martensite is a viable technique for grain refinement of DP steels, where a microstructure consisting of ferrite grains with average grain size of less than 5â¯Î¼m and fine martensite islands can be easily obtained. This DP steel exhibits much better strength-ductility balance compared with that obtained by intercritical annealing of the ferritic-pearlitic microstructure due to much finer microstructure and enhancement of work-hardening behavior in the former. The fine-grained microstructure is also obtained at higher intercritical annealing temperatures for the aim of increasing the volume fraction of martensite. Accordingly, the work-hardening response and the overall mechanical properties are enhanced.
Related Topics
Physical Sciences and Engineering
Materials Science
Surfaces, Coatings and Films
Authors
Mohammad Alibeyki, Hamed Mirzadeh, Mostafa Najafi,