Article ID | Journal | Published Year | Pages | File Type |
---|---|---|---|---|
8088985 | Geothermics | 2015 | 12 Pages |
Abstract
In this study, the bulk thermal conductivity (TC) of 26 rock samples representing different types of granulite-facies rocks, i.e., felsic, intermediate and mafic granulites, from the Southern Granulite Province, India, is measured at dry and saturated conditions with the optical-scanning method. Thermal conductivity is also calculated from modal mineralogy (determined by XRD and EPMA), applying several mixing models commonly used in thermal studies. Most rocks are fine- to medium-grained equigranular in texture. All samples are isotropic to weakly anisotropic and possess low porosities (<2%). Measured TC values range between 2.5 and 3.0 W mâ1 Kâ1 for felsic granulites, between 2.5 and 3.5 W mâ1 Kâ1 for intermediate granulites and between 2.4 and 2.7 W mâ1 Kâ1 for mafic granulites. Considering this data and literature compilations, rocks representative for the lower continental crust typically display values between 2 and 3 W mâ1 Kâ1 at ambient temperature and pressure conditions. Depending on the mixing model and the mineral TC value used in the calculations, measured and calculated bulk TC could be properly fitted. For mean values of mineral TCs, the harmonic mean provides an almost perfect fit, with a mean deviation of â1 ± 6% (1Ï). However, the implication of that correspondence would be that minerals and pores are predominantly aligned parallel, which is in apparent contrast to the texture of the rocks studied here. The geometric mean, which does not consider any layering of minerals or pores in the rock and, thus, should be in better harmony with the textural characteristics of the studied high-grade rocks, matches the measured TC data very well, if minimal minerals TCs reported in the literature are applied (mean deviation 5 ± 8%). Thus, if samples appropriate for laboratory measurements (in terms of sample size or physical-chemical-mechanical condition) are not available, bulk TC of high-grade metamorphic rocks with low anisotropy and porosity could be satisfactorily good assessed from modal mineralogy, using the data sets for mineral TC applied in this study. Further work is required on the applicability of mixing models to compute TC of other rock types, e.g., of igneous and sedimentary rocks.
Keywords
Related Topics
Physical Sciences and Engineering
Earth and Planetary Sciences
Geochemistry and Petrology
Authors
Labani Ray, Hans-Jürgen Förster, Andrea Förster, Sven Fuchs, Rudolf Naumann, Oona Appelt,