| Article ID | Journal | Published Year | Pages | File Type |
|---|---|---|---|---|
| 8096093 | Journal of Cleaner Production | 2018 | 12 Pages |
Abstract
operates, respectively. It was found that the distortion of the top region of the sintered workpieces was reduced about 97% when there was 5â¯mm of allowance removal and 82% for 1â¯mm of allowance. In the bottom region, the reduction was about 91% for removal of 5â¯mm of allowance and 48% for 1â¯mm. Cutting tool wear, cutting force, and surface roughness of green and sintered workpieces were also analyzed. In general, the influence of tool wear on surface roughness of sintered pieces and the correlation between surface roughness of the sintered pieces and the corresponding green ones were observed.
Related Topics
Physical Sciences and Engineering
Energy
Renewable Energy, Sustainability and the Environment
Authors
L.E.A. Sanchez, G. Bukvic, A.A. Fiocchi, C.A. Fortulan,