Predicting the physico-mechanical properties of rocks from electrical impedance spectroscopy measurements

Electrical resistivity values of eight different samples cored from a fault breccia were measured using an impedance analyser. The uniaxial compressive strength, elastic modulus, point load strength, Schmidt hammer value, P-wave velocity, density and porosity values of the samples were determined in the laboratory. Electrical resistivity values were correlated with the corresponding physico-mechanical properties using the method of least-squares regression and the derived equations were checked by the t and F-test. A strong logarithmic relation between uniaxial compressive strength and resistivity was found. The relation between elastic modulus and resistivity is significant and follows a logarithmic function. Density was linearly, and porosity was exponentially correlated with resistivity.It may be concluded that electrical resistivity can be used as a representative measure of rock properties, particularly for characterizing rocks for which regularly shaped specimen are difficult to obtain. However, the effect of different rock types on the correlations must be further investigated. Additionally, the effect of certain minerals on the rock's resistivity must be taken into account, especially when testing dry or partially saturated rocks.