Assessment of CryoSat-2 SAR mode wind and wave data

Significant wave height (SWH) and surface wind speed (WS) products from the CryoSat-2 Delay-Doppler, which is commonly known as Synthetic Aperture Radar (SAR), Mode are validated against operational ECMWF atmospheric and wave model results in addition to available observations from buoys, platforms and Jason-2 altimeter. The CryoSat-2 SAR Mode data are processed from Level 1A (also known as Full Bit Rate, FBR, in the CryoSat-2 terminology) up to L1B in accordance to the Delay-Doppler algorithm, and then retracked using SAMOSA (SAR Altimetry MOde Studies and Applications) SAR return waveform model, as implemented in the Grid Processing on Demand (G-POD) service called SAR Versatile Altimetric Toolkit for Ocean Research and Exploitation (SARvatore). The data cover two geographic boxes: one in the northeast Atlantic Ocean (NE Atlantic Box) for the period from 6 September 2010 to 30 June 2014 and the other is in the eastern Pacific (Pacific Box) for the period from 7 May 2012 to 30 June 2014. The amount of data is limited by the CryoSat-2 SAR Mode acquisition mask over ocean but is large enough to ensure robustness and significance of the results. The results show that the quality of both CryoSat-2 SAR SWH and WS products is very high when compared to typical altimetry mission requirements. When compared against model and in-situ data, the correlation coefficients are as high as 0.98 for SWH and 0.95 for WS while the bias and standard deviation of the difference is less than 5% and 0.3 m, respectively, for SWH and less than 0.3 m/s and 1.3 m/s, respectively for WS. The results show that the quality of both CryoSat-2 SAR SWH and WS products is in line with Jason-2 performances and satisfies the typical altimetry mission requirements.