Influence of hot deformation on texture and magnetic properties of strip cast non-oriented electrical steel

The present study focuses on improving the magnetic properties and decreasing the anisotropy in non-oriented electrical steel by optimizing {1 0 0} recrystallization texture. As-cast Fe-1.3%Si strip with {1 0 0} texture produced by strip casting was subjected to hot rolling in the ferrite region, cold rolling, and recrystallization annealing. Magnetic properties and texture evolution after different stages of processing were studied. Annealed sample without hot rolling exhibited pronounced Cube and Goss texture, which led to high permeability but induced a large difference (∼0.15 T) in magnetic induction B50 between the maximum at 0° and minimum at 45° to the rolling direction. The introduction of hot rolling with 17-40% reduction weakened the intensity of recrystallization texture and had small influence on the nature of texture and magnetic induction. However, relatively complete {1 0 0} recrystallization texture was developed in the sample with hot rolling of 55% reduction. On the other hand, the average grain size of annealed sheets gradually increased with the increased hot rolling reduction. As a result, the magnetic induction and the core loss was optimized together with the improvement of anisotropy. The development of recrystallization texture is discussed on the basis of the deformed microstructure and nucleation mechanism, while the magnetic properties are correlated to the magnetic quality of the texture.