Article ID Journal Published Year Pages File Type
821011 Composites Science and Technology 2011 7 Pages PDF
Abstract

Stamping is one of the most effective ways to form textile composites in industry for providing high-strength, low-weight and cost-effective products. This paper presents a fully continuum mechanics-based approach for stamping simulation of textile fiber reinforced composites by using finite element (FE) method. A previously developed non-orthogonal constitutive model is used to represent the anisotropic mechanical behavior of textile composites under large deformation during stamping. Simulation are performed on a balanced plain weave composite with 0°/90° and ±45° as initial yarn orientation over a benchmark double dome device. Simulation results show good agreement with experimental output in terms of a number of parameters selected for comparison. The effects of meshing and shear moduli obtained from bias extension test and picture frame test on forming simulation results are also investigated.

Related Topics
Physical Sciences and Engineering Engineering Engineering (General)
Authors
, ,