Fretting and wear behaviors of Ni/nano-WC composite coatings in dry and wet conditions

•The friction and wear properties of Ni/nano-WC composite were studied.•Nano-WC reinforcement decreased friction coefficient in dry and wet conditions.•Nano-WC reinforcement fraction was seen to be 12 wt.%.•Nanohardness increased by 27% compared to nickel without WC reinforcements.•Ennoblement of OCP corresponding to the Ni/nano-WC composite coating.

The fretting and wear behaviors of Ni/nano-WC composite coatings were studied by considering the effect of fretting frequency of 1 Hz during 10,000 cycles, at different applied loads in dry or wet conditions. The studies were performed on a ball-on-disk tribometer and the results were compared with pure Ni coating. The nanohardness of pure Ni and Ni/nano-WC composite coatings was tested by nanoindentation technique. To evaluate the wet wear (tribocorrosion) behavior the open circuit potential (OCP) was measured before, during and after the fretting tests at room temperature in the solution that simulates the primary water circuit of Pressurized Water Reactors (PWRs). The results show that Ni/nano-WC composite coatings exhibited a low friction coefficient, high nanohardness and wear resistance compared with pure Ni coatings under similar experimental conditions. Ni/nano-WC composite coatings were obtained on stainless steel support by electrochemical codeposition of nano-sized WC particles (diameter size of ∼60 nm) with nickel, from a standard nickel Watts plating bath. The surface morphology and the composition of the coatings were characterized by scanning electron microscopy (SEM) and energy dispersive spectroscopy (EDX) respectively.

Graphical abstractFigure optionsDownload full-size imageDownload as PowerPoint slide