Low cycle fatigue of an extruded Mg–3Nd–0.2Zn–0.5Zr magnesium alloy

•A large number of smaller second-phase particles are present inside the grains.•A precipitate free zone (PFZ) appears along grain boundaries with larger particles.•The extruded Mg–3Nd–0.2Zn–0.5Zr Mg alloy exhibits asymmetrical hysteresis loops.•Cyclic softening occurs at the low strain amplitude.

The purpose of this study was to evaluate strain-controlled cyclic deformation behavior of an extruded Mg–3Nd–0.2Zn–0.5Zr (NZ30K) magnesium alloy. The microstructure of this alloy consisted of a bimodal microstructure with equiaxed recrystallized grains and unrecrystallized coarse grains along with a large number of smaller second-phase particles present inside the grains and larger particles along the grain boundaries alongside a characteristic precipitate free zone (PFZ). The average grain size was about approximately 5–7 μm. It was observed that unlike the higher RE-containing Mg–10Gd–3Y–0.5Zr (GW103K) magnesium alloy, the NZ30K alloy exhibited asymmetrical hysteresis loops in tension and compression in the fully reversed strain-control tests at a strain ratio of Rε = −1. This was mainly due to the presence of relatively stronger crystallographic texture, PFZ, and the resultant twinning–detwinning activities during cyclic deformation. While this alloy exhibited cyclic softening at lower strain amplitudes and cyclic hardening at higher strain amplitudes, it had an equivalent fatigue life to that of other extruded Mg alloys. Fatigue crack was observed to initiate from the specimen surface with some isolated facets of the cleavage-like planes near the initiation site. Crack propagation was basically characterized by serrated fatigue striations.