Article ID Journal Published Year Pages File Type
830365 Materials & Design (1980-2015) 2013 8 Pages PDF
Abstract

This paper presents the influence of shrinkage-reducing (SHR) and superplasticizing and set-retarding admixtures (SSRe) on the properties of slag pastes and mortars activated by liquid sodium silicate with different dosage and modulus ratio. Properties in the fresh and hardened state for these binders were investigated by means of measuring some properties including setting time, flowability, flexural strength, compressive strength, carbonation and shrinkage. In this study, fifteen pastes and mortars were prepared. Liquid sodium silicate was used to activate the slag at two sodium concentrations, 4% and 6% by mass of slag. Liquid sodium silicate and sodium hydroxide were blended to obtain 0.75 and 1 modulus ratio of SiO2/Na2O. Results showed that although the higher percentage of sodium in the activator produced a higher strength, workability and setting times rapidly decreased with the higher sodium concentration due to instantaneous reaction and quick hardening of slag activated by liquid sodium silicate. None of the admixtures generally had an impact on the setting times of alkali-activated slag (AAS) pastes. SSRe admixture increased the flow rate of AAS mortars while SHR admixture partially affected the flow values of AAS mortars. SHR admixture exhibited a slight decrease in the carbonation depths of AAS mortars. SSRe and particularly SHR chemical admixtures reduced the shrinkage of AAS mortars. However, the shrinkage values of AAS mortars still were higher than those of ordinary Portland cement (NPC) mortars. Curing conditions had a significant effect on the mechanical behavior in the hardened state of AAS mortars compared to NPC mortars.

► Activation of slag by liquid sodium silicate produced rapid set and high shrinkage. ► Strengths of AAS mortars increased with an increase in the activator Na dosage. ► Sensitivity of AAS mortars to dry curing conditions was higher than OPC mortars. ► SSRe and especially SHR chemical admixtures reduced the shrinkage of AAS mortars. ► SSRe admixture had no impact on carbonation while SHR admixture had little effect.

Related Topics
Physical Sciences and Engineering Engineering Engineering (General)
Authors
, , , ,