| Article ID | Journal | Published Year | Pages | File Type |
|---|---|---|---|---|
| 831504 | Materials & Design (1980-2015) | 2011 | 7 Pages |
The single-pass friction stir weld of aluminum 2219-T6 with weld-defects was repaired by overlapping friction stir welding technique. However, without any post weld heat treatment process, it was found that the phenomena of abnormal particle-coarsening of Al2Cu had occurred in the overlapping friction stir repair welds. The detecting results of non-destructive X-ray inspection proved that not only one group of repair FSW process parameters could lead to occurrence of the abnormal phenomena. And the abnormally coarsened particles always appeared on the advancing side of repair welds rather than the retreating side where the fracture behaviors occurred after mechanical tensile testing. The size of the biggest particle lying in the dark bands of ‘Onion-rings’ was more than 150 μm. After the related investigation by scanning electron microscope and X-ray energy spectrometer, three types of formation mechanisms were proposed for reasonably explaining the abnormal phenomenon: Aggregation Mechanism, Diffusion Mechanisms I and II. Aggregation Mechanism was according to the motion-laws of stir-pin. Diffusion Mechanisms were based on the classical theories of precipitate growth in metallic systems. The combined action of the three detailed mechanisms contributed to the abnormal coarsening behavior of Al2Cu particles in the friction stir repair weld.
► Defective friction stir welds were repaired by overlapping FSW technique. ► Abnormal Al2Cu-coarsening phenomena were found in 2219-T6 friction stir repair weld. ► Three formation mechanisms were proposed for reasonable explanations.
