Partition and size distribution of heavy metals in the flue gas from municipal solid waste incinerators in Taiwan

This study investigates the partition of heavy metals in both solid and gas phases in the flue gas from municipal solid waste (MSW) incinerators. Six MSW incinerators in Taiwan were examined and heavy metals in the flue gas at the inlets and outlets of air pollution control devices (APCDs) were analyzed. Heavy metals including Hg, Pb, Cd, Zn, Cu and Cr were sampled by USEPA Method 29 and further analyzed using inductively coupled plasma-mass spectroscopy (ICP-MS) and cold vapor atomic absorption spectrometry (CVAAS). Experimental results revealed that the removal efficiencies of the APCDs for the heavy metals Pb, Cd, Zn, Cu and Cr greatly exceeded 90%, but that of Hg did not. Two groups of heavy metals upstream of APCDs were observed. Pb, Cd, Zn, Cu and Cr were present mainly in the solid phase with a solid to gas ratio (S/G) of over 12.3. However, in most cases, mercury appeared mainly in the gas phase with an S/G ratio from 0.15 to 1.04, because it has a low boiling point. Additionally, treatment with the APCDs increased the S/G ratio of mercury because gaseous mercury could be removed by injecting powdered activated carbon (PAC) into the flue gas. Moreover, the distribution of particle sizes in the solid phase was bimodal. Finer particles (dp ⩽ 2.5 μm) contained more Pb, Cd, Zn and Cu, whereas coarser particles (dp > 2.5 μm) contained more Cr and Hg.