Can pseudotachylytes be used to infer earthquake source parameters? An example of limitations in the study of exhumed faults

The above conditions are all satisfied in the case of the Gole Larghe Fault Zone, which consists of hundreds subparallel strike-slip faults that cut tonalites of the Adamello batholith (Italy). The thickness of pseudotachylyte-bearing faults increases with displacement. From displacement/thickness ratios and energy balance calculations, we determined the dynamic shear resistance for several pseudotachylyte-bearing faults. In the same faults, the fractal dimension of the fault profile increases from 1.0 to 1.16 with displacement. This was also observed in experiments where steady-state friction in the presence of melt was achieved (Hirose, T., Shimamoto, T., 2003. Fractal dimension of molten surfaces as a possible parameter to infer the slip-weakening distance of faults from natural pseudotachylytes. Journal of Structural Geology 25, 1569-1574). However, we will show that the estimate of the dynamic shear stress resistance, average dynamic friction and slip-weakening distance in the studied faults is limited by the uncertainties to attribute the measured displacement to a single seismic rupture. Since many pseudotachylytes in the upper seismogenic crust overprint preexisting cataclasites, it is suggested that future field and experimental work should be addressed to determine microstructural indicators (i.e. evolution of cataclastic fabric with displacement) within cataclasites, which might constrain the contribution of the cataclastic, pre-pseudotachylyte displacement to the total displacement accommodated by the fault.