Article ID | Journal | Published Year | Pages | File Type |
---|---|---|---|---|
9637367 | Proceedings of the Combustion Institute | 2005 | 9 Pages |
Abstract
Instantaneous and simultaneous measurements of two-dimensional temperature and OH-LIF profiles by combining Rayleigh scattering with laser induced fluorescence (LIF) were demonstrated in a nitrogen-diluted hydrogen (H2 30%Â +Â N2 70%) laminar normal diffusion flame interacting with a large-scale vortex by oscillating central fuel flow or in an inverse diffusion flame by oscillating central airflow. The dynamic behavior of the diffusion flame extinction and reignition during the flame-vortex interaction processes was investigated. The results obtained are described as follows. (1) The width of the reaction zone decreases remarkably, and a decrease in flame temperature and OH-LIF is seen with increasing central airflow in an inverse diffusion flame. OH-LIF increases, and temperature does not change with increasing central fuel flow in a normal diffusion flame. The computations predict the experimental results well, and it is revealed that flame temperature characteristics result from the preferential diffusion of heat and species, which induces excess enthalpy or on enthalpy deficit, and an increase or decrease in H2 mole fraction in the flame. (2) When a large velocity fluctuation is given to the central flow, the temperature and the OH-LIF at the reaction zone become thin at the convex and circumferential part of the vortex where a high temperature layer exists, and the temperature at the reaction zone is lowered in the inverse flame and the normal flame. (3) The width and temperature of the reaction zone interacting with the vortex recover quickly to that of the laminar steady flame after the vortex passing in the normal flame, but the recovery to that of the steady flame after the vortex passing is delayed in the inverse flame. (4) When a remarkably large velocity fluctuation is given to the central airflow in the inverse flame, thinning of temperature and reaction zone starts at the convex and circumferential part of the vortex, resulting in a and flame extinction completely occurs at the tail part of the vortex and makes the pair of edge flames. The outside edge flame reignites and connects with the upstream reaction zone. The inside edge flame finally extinguishes as the supply of fuel is interrupted by the outside edge flame.
Related Topics
Physical Sciences and Engineering
Chemical Engineering
Chemical Engineering (General)
Authors
Masaharu Komiyama, Tomoya Fujimura, Toshimi Takagi, Shinichi Kinoshita,