Article ID Journal Published Year Pages File Type
9679321 Wear 2005 9 Pages PDF
Abstract
The purposes of the current study were to determine whether the wear of brake lining materials can be measured in shorter-term laboratory tests, and if so, to determine to what extent the relative ranking of several lining materials' wear resistance depends on the method of testing. To investigate these issues, three commercial truck brake lining materials were worn against gray cast iron using three different laboratory-scale wear testing machines. Assessments of wear by gravimetric methods and dimensional changes using the same test apparatus were compared. The three linings ranked in similar order in all three kinds of wear tests, but the relative differences between the wear of one lining and another differed among the test methods. Results are discussed in terms of what test conditions are required to simulate brake lining wear in trucks, and how in situ lining material aging and transfer film formation can affect the wear of brake lining materials. Differences in the entrapment of third-bodies entering the contact had an important influence on the wear results and an additional set of block-on-ring experiments was conducted to demonstrate that effect. Removing wear debris with a wiper pad altered the relative wear ranking of the three materials.
Related Topics
Physical Sciences and Engineering Chemical Engineering Colloid and Surface Chemistry
Authors
, ,